Onkyo R-811RDS - Using the Timer; Sleep Facility Operation; Cancelling the Sleep Setting; Checking Timer Settings

Us
i
n
g
the
ti
mer
(Use
of
the
Onkyo
Liverpool
Separate
Collection)
Make
sure
that
the
clock
has
been
set
correctly
before
setting
the
timer.
(See
page
12)
Make
sure
that
the
source
component
is
connected
to
an
amplifier
with
a
timer
function,
and
that
the
CD
or
cassette
tape
has
been
inserted
into
the
appropriate
component.
ene 4— Lo / fe | 2
PGM/CHK “lac ny i
WEEKDAY WEEKEND
Example 1
Example 2
Example 3
Weed
OFF ON OFF
The sleep timer can power off the system after a specified time
period.
To operate this function, use the remote control supplied with your
tuner amplifier.
1. Start the source playing that you would like to listen to.
(CD, Tape or radio broadcast)
2. Set the amount of time after which you want the system to
turn off.
The sleep timer works for up to 90 minutes.
You can shorten the timer by 10 minute increments by pressing
the SLEEP button until the desired time has been reached.
When the set time comes, the power will be switched off automat-
ically.
Press the SLEEP button until it changes to the source display you
are listening to.
or
The timer can also be cancelled while it is in operation, by turning
off the power.
1. Press ihe PROGRAM/CHECK ation’ twice to enter pro-
gram check mode.
2. Press the button corresponding to the timer you wish to
check. (WEEKDAY, WEEKEND, ONCE or REC)
The “ON” time is shown and flashes on the display. If you
press the same button again, or leave it for 5 seconds, the
“OFF” time then the source will be shown.
_
You are able to make up to 3 timer settings — one for WEEK-
DAY, one for ONCE, and one for RECORD, provided the none
of the settings overlap,
Note in example 2 that the OFF time for ONCE tums off the unit
in the middle of the WEEKDAY period, because they overlap.
23