information related to your LAN, such as Subnet Mask and Gateway.
Network Standby
Default Value: Off
You can turn on the power of the unit via network using an application
such as Onkyo Remote.
"On": Use this function
"Off": Do not use this function
When "Network Standby" is used, the power consumption increases
even when the unit is on standby. However, the increase in power
consumption is kept to a minimum by automatically entering the
HYBRID STANDBY mode, where only the essential circuit is
operating.
Wi-Fi
Default Value: Off(Wired)
Connect the unit to network via wireless LAN router.
"On": Wireless LAN connection
"Off(Wired)": Wired LAN connection
Wi-Fi Setup
Default Value: –
You can configure wireless LAN settings by pressing ENTER when
"Start" is displayed.
Wi-Fi Status
Default Value: –
The information of the connected access point will be displayed.
"SSID": SSID of the connected access point.
"Security": Security method of the connected access point.
"Signal": Signal strength of the connected access point.
"Status": Status of the connected access point.
MAC Address
Default Value: –
This is the MAC address of the AV receiver.
This value is specific to the component and cannot be changed.
To Next Page
Loading...
