148
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
(*1) You cannot select any mode other than PureAudio, Stereo, AllCh Stereo and Full Mono if the sampling rate is 5.6/11.2 MHz.
(*2) A center speaker or surround speakers need to be installed.
(*3) If the input source is Blu-ray Disc and the speaker layout is 5.1 ch or less, DD+ cannot be selected. Instead, the listening mode for DD can be selected.
(*4) This can only be selected when no surround back speaker is connected.
(*5) Surround back speakers need to be installed. Can be selected when the input format is 5.1 ch.
(*6) If the input format is any of the following and the channel count is monaural, this listening mode becomes unavailable.
– DTS, DTS 96/24, DTS Express, DTS-HD HR, DTS-HD MSTR, PCM, music le
(*7) Cannot be selected when the IMAX Mode ( p166) is set to "Off" (the default value is Auto).
(*8) Surround speakers or height speakers need to be installed.
(*9) A center speaker, surround speakers, or height speakers need to be installed.
(*10) Cannot be selected if "Speaker Virtualizer" ( p165) is set to "Off".
(*11) Surround speakers need to be installed.
(*12) Cannot be selected when the input format is monaural.
(*13) The listening mode displayed depends on the speaker layout ( p132, 133). Furthermore, when the setting for "Speaker Virtualizer" ( p165) is "Off" (the
default value is On), then modes other than Atmos and Dsur cannot be selected.
(*14) Can only be selected when the IMAX Mode ( p166) is set to "Off" (the default value is Auto).
Speaker Layouts and Selectable Listening
Modes ( p129)
To Next Page
Loading...
