Onkyo TX-RZ3400

161
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
Setting Item Default Value Setting Details
Double Bass On This can be selected only when "Conguration" -
"Subwoofer" is set to "1ch" or "2ch" and "Front" is
set to "Full Band".
Bass output is boosted by feeding bass sounds
from the front right and left, and center speakers to
the subwoofer.
"On": Bass output is boosted.
"Off": Bass output is not boosted.
• This function is not automatically set even if
AccuEQ Room Calibration is performed.
• This setting is disabled when the IMAX sound mode has been applied. However, when
the "IMAX User Setting" (
p166) is "Manual" (default value is Auto), it is enabled.
 3. Distance
Set the distance from each speaker to the listening position.
Setting Item Default Value Setting Details
Front Left 12' 0"/3.60 m Specify the distance between each speaker and
the listening position.
Center 12' 0"/3.60 m Specify the distance between each speaker and
the listening position.
Front Right 12' 0"/3.60 m Specify the distance between each speaker and
the listening position.
Height 1 Left 9' 0"/2.70 m Specify the distance between each speaker and
the listening position.
Height 1 Right 9' 0"/2.70 m Specify the distance between each speaker and
the listening position.
Height 2 Left 9' 0"/2.70 m Specify the distance between each speaker and
the listening position.
Height 2 Right 9' 0"/2.70 m Specify the distance between each speaker and
the listening position.
Surround Right 7' 0"/2.10 m Specify the distance between each speaker and
the listening position.
Surr Back Right 7' 0"/2.10 m Specify the distance between each speaker and
the listening position.
Surr Back Left 7' 0"/2.10 m Specify the distance between each speaker and
the listening position.
Surround Left 7' 0"/2.10 m Specify the distance between each speaker and
the listening position.
Subwoofer 1 12' 0"/3.60 m Specify the distance between each speaker and
the listening position.
Subwoofer 2 12' 0"/3.60 m Specify the distance between each speaker and
the listening position.
• Default values vary depending on the regions.
•
Distance units can be switched by pressing MODE on the remote controller. When the unit
is set as feet, you can set between 0' 0" 1/2 and 30' 0" in increments of 1/2. When the unit
is set as meters, you can set between 0.01 m and 9.00 m in increments of 0.01 m.