163
Front Panel≫ Rear Panel≫ Remote≫
Contents
≫
Connections
≫
Playback
≫
Setup
≫
5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
Setting Item Default Value Setting Details
Dolby Enabled
Speaker to Ceiling
6' 0"/1.80 m Set the distance between the Dolby Enabled
Speaker and the ceiling. Select between " 0' 0"
1/2"/"0.01 m" and "15.0 ft/4.50 m" (1/2 / 0.01 m
units).
• The unit of distance (ft/m) is displayed using the
unit selected for the "Distance" setting.
AccuReex Off You can enhance the reection effect of Dolby
Enabled Speakers from the ceiling.
"Off": When this function is not used
"On": When this function is used
• This setting can be selected when "Conguration" - "Height 1 Speaker"/"Height 2
Speaker" is set to "Dolby Speaker".
6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of different sound ranges for each speaker. You can set three
different equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to ve bands for the Subwoofer and nine bands
for the other speakers.
You can check what the settings are for each input selector with "Check".
Setting Item Default Value Setting Details
Front 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Center 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Setting Item Default Value Setting Details
Height 1 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Height 2 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Surround 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Surround Back 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "16 kHz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Subwoofer 0.0 dB
After selecting the speaker frequency between
"25 Hz" and "160 Hz" with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and
"+6.0 dB" with / .
Check -
You can check the settings allocated to each input
selector.
• Settings can be made for each input selector
with
"
AccuEQ
"
-
"
Manual Equalizer
"
( p181)
in the Quick Menu.
• Depending on the input source or listening mode setting, the desired effect may not be
achieved.
To Next Page
Loading...
