Onkyo TX-RZ70 - Page 138

138
SetupSetup
2. Speaker
 5. Dolby Enabled Speaker
Change the settings of Dolby Enabled Speakers.
• This setting can be selected when "Conguration" - "Height 1 Speaker" /
"Height 2 Speaker" is set to "Dolby Speaker".
 Distance from the ceiling (Default Value: 6.0"/1.80 m)
Set the distance between the Dolby Enabled Speaker and the ceiling. Select
between "0' 0" 1/2"/"0.01 m" and "15' 0"/"4.50 m" ("1/2 ft"/"0.01 m" units).
• The unit of distance (ft/m) is displayed using the unit selected for the
"Distance" setting.
 AccuReex (Default Value: O󰀨)
You can enhance the reection e󰀨ect of Dolby Enabled Speakers from the
ceiling.
• The function is not e󰀨ective if the listening mode is Pure Audio or Direct.
• The function is not e󰀨ective if "Dirac Live" ( →p93) has been enabled.
O󰀨 When this function is not used
On When this function is used
 6. Equalizer Settings
You can adjust the output volume of the range for each connected speaker.
Adjust the volume of di󰀨erent sound ranges for each speaker. You can set three
di󰀨erent equalizers in Preset 1 to 3. The number of frequencies that can be
selected for each speaker is up to ve bands for the Subwoofer and nine bands
for the other speakers.
 Preset 1
Preset 2
Preset 3
Check
Select the Preset to be set with the cursors / , then press the ENTER
button.
When you select "Check", you can check what the settings are for each input
selector.
Front (Default Value: 0.0dB)
Center (Default Value: 0.0dB)
Height 1 (Default Value: 0.0dB)
Height 2 (Default Value: 0.0dB)
Surround (Default Value: 0.0dB)
Surround Back (Default Value: 0.0dB)
Subwoofer (Default Value: 0.0dB)
Select the speaker to be set with the cursors / , then press the ENTER
button. Next, after selecting the speaker frequency from between "25 Hz" and
"16 kHz" ("25 Hz" and "160 Hz" for Subwoofer) with the cursors / , adjust
the volume of that frequency between "-6.0 dB" and "+6.0 dB" with / .
• Depending on the input source or listening mode setting, the desired e󰀨ect
may not be achieved.