Onkyo TX-RZ70 - Page 139

139
SetupSetup
2. Speaker
(Height 1 Left, Height 1 Right, Height 2 Left, Height 2 Right, Surround Back):
• Depending on the use of the ZONE speakers, it may not be possible to select
this setting.
(Subwoofer):
• This cannot be selected if "Conguration" - "Subwoofer" is set to "No".
 7. THX Audio
Change the THX Audio settings.
 Back Speaker Spacing (Default Value: >4.0 ft/>1.2 m)
Select the distance between the surround back speakers from "<1.0 ft/<0.3 m",
"1.0 - 4.0 ft/0.3 - 1.2 m", and ">4.0 ft/>1.2 m".
• The unit of distance (ft/m) is displayed using the unit selected for the
"Distance" setting.
• The setting cannot be changed if "Conguration" - "Zone Speaker" is set to a
selection item other than "No" and Zone 2 is on.
• If the item cannot be selected even though connection is correct, check if
the setting in "Conguration" - "Speaker Channels" matches the number of
connected channels.
 THX Ultra / Select Subwoofer (Default Value: No)
Set whether a THX-certied subwoofer is connected or not.
• This cannot be selected if "Conguration" - "Subwoofer" is set to "No".
Yes When a THX-certied subwoofer is connected
No When a THX-certied subwoofer is not connected
 BGC (Default Value: O󰀨)
Correct an emphasized bass sound when listening to music near the wall or
boundary of the room due to layout limitation of the listening room. The THX
Select receivers can adjust the balance of bass sound.
• In the following cases, the setting cannot be changed:
– "Conguration" - "Subwoofer" is set to "No".
– "THX Ultra / Select Subwoofer" is set to "No".
– One of the slots has been selected with "Dirac Live" ( →p93).
On When this function is used
O󰀨 When this function is not used