Connecting antennas
To use the tuner of the TX-SR701/701E/601/601 E, it is necessary to
prepare the supplied FM and AM antennas.
• Adjustment and placement of the FM and AM antennas for
better reception must be done while listening to a sta/ion
broadcast.
• If better reception cannot be obtained, then placement of an
outside antenna is recommended.
Assembling the AM loop antenna
Assemble the loop antenna as shown ill the illustra/ion.
• Refer to "Connecting the AM loop antenna" below for details
on how to connect the loop antenna.
insert into the hole
I Connecting the included antennas
Connecting the FM indoor antenna:
'Ihe FM indoor anlelma is for indoor use only. During use, exlend
the anlenna and adjust its orienta/ion until the clearest signal is
x-eceived. Fix it with push pins or similar items in the position that
will cause the least amount of distortion.
If the xeception is not very clear with the allached FM indoor
antenna, the use of an outdoor antenna is recommended.
Connecting the AM loop antenna:
'Ihe AM loop antenna is for indoor use only. Set it in the direction
and position whexe you receive the clearest sound. Put it as far away
as possible from the TX-SR701/701E/601/601E, televisions,
speaker cables, and power cords.
If the reception is not very clear with the attached AM indoor
antenna, the use of an outdoor antenna is recommended.
(indoor)
AM loop antenna
Other models
FM antenna
Connecting the AM antenna cable
1. Press down the lever at the antenna terminal,
2. Insert the wire into the terminal hole.
3. Release the lever.
USA and
Canadian
models
Hint:
Either of the split ends of the AM antenna can be connected to
either terminal. Unlike speaker cabling, there is no polarily for AM
broadcast signals.
29
To Next Page
Loading...
