10
4 Installation
x Observe all safety and warning information (see
the “Safety Instructions and Warnings” chapter).
x Follow the enclosed manufacturer‘s information
x Make sure that the area below the cooktop has
a sufficient air supply.
4.1 General installation instructions
x The power supply cable must be provided by the
customer.
x The appliance must not be installed above
cooling devices, dishwashers, stoves, ovens,
washing machines or dryers.
x The contact surface of the worktops and wall
sealing strips must be made of a heat-resistant
PDWHULDOXSWRDSSUR[ௗ&
x Worktop cut-outs must be moisture-sealed using
suitable means and, where necessary, fitted
with a thermal insulator.
x The integrated cooktop extractor must not be
used with other cooktops.
x To ensure that the cooktops perform optimally at
all times, there must be sufficient ventilation
beneath the cooktops.
x The performance of the cooktops is affected or
the cooktops overheat if the warm air beneath
the cooktops cannot escape.
x If a cooktop overheats, the power is
automatically reduced or the cooktop is switched
off completely (see “Overheating protection”).
x If cable protection (false floor) is planned
beneath the appliance, this must be fitted so it
does not obstruct ventilation.
4.2 Scope of delivery
Scope of Delivery: Opera Quantity
Cooktop with integrated extractor 1
Air inlet flap 1
Grease filter 2
Carbon filter (Only on DPR78C__) 2
Operating and installation instructions 1
Cleaning instructions 1
Duct tape 1
Sealing tape ±5 m.
Bag containing assembly parts 1
Metal sheet black canalization 1
Metal sheet telescopic extension 1
Vertical ducting 1
90° bend ducting 1
4.3 Tools and aids
The following special tools are required to correctly
install the cooktop:
x Compass saw or hand saw
x Meter
x Torx 25 screwdriver
x Cross-head screwdriver
x Black, heat-resistant silicone sealant
EN
To Next Page
Loading...
