Optimum 3300260 - Safety Check; Personal Protective Equipment

Safety
Version 1.2.4 - 2022-10-2612 Translation of original instruction
S275N | S275NV
EN
S275N_S275NV_GB_1.fm
1.8 Safety check
Check the metal band saw at least once per shift. Inform the person responsible immediately of
any damage, defects or changes in the operating function.
Check all safety devices
 at the beginning of each shift (with the machine stopped),
 once a week (with the machine in operation),
 after all maintenance and repair work.
Check that prohibition, warning and information signs and the labels on the metal band saw
 are legible (clean them, if necessary)
 are complete.
INFORMATION
Organise the checks according to the following table;
1.9 Personal protective equipment
For some works you need personnel protective equipment as protective equipment. This
includes:
 Safety helmet,
 protective glasses or face guard,
 protective gloves,
 safety shoes with steel toe caps,
 ear protection.
Before starting work make sure that the required personnel protective equipment is available at
the work place.
CAUTION!
Dirty or contaminated personnel protective equipment can cause illness.
Clean your personal protective equipment
 after each use,
 regularly once a week.
General check
Equipment Check OK
Guards Mounted, firmly bolted and not damaged
Signs,
Markers
Installed and legible
Date: checked by (signature):
Functional check
Equipment Check OK
Emergency-stop button When the Emergency-stop push button is activated, the metal band
saw must switch off.
Position switch
Protective cover saw
arch
The metal band saw only switches on when the protective cover is
being closed.
Date: checked by (signature):