Optimum 3300260 - Liability Claims for Defects; Warranty

Appendix
Version 1.2.4 - 2022-10-2664 Translation of original instruction
S275N | S275NV
EN
S275N_S275NV_GB_8.fm
8.4 Liability Claims for Defects / Warranty
Beside the legal liability claims for defects of the customer towards the seller, the manufacturer
of the product, OPTIMUM GmbH, Robert-Pfleger-Straße 26, D-96103 Hallstadt, does not grant
any further warranties unless they are listed below or were promised in the framework of a
single contractual provision.
 The processing of the liability claims or of the warranty is performed as chosen by
OPTIMUM GmbH either directly or through one of its dealers.
Any defective products or components of such products will either be repaired or replaced
by components which are free from defects. Ownership of replaced products or
components is transferred to OPTIMUM Maschinen Germany GmbH.
 The automatically generated original proof of purchase which shows the date of purchase,
the type of machine and the serial number, if applicable, is the precondition in order to
assert liability or warranty claims. If the original proof of purchase is not presented, we are
not able to perform any services.
 Defects resulting from the following circumstances are excluded from liability and warranty
claims:
 Using the product beyond the technical options and proper use, in particular due to
overstraining of the machine.
 Any defects arising by one's own fault due to faulty operations or if the operating manual is
disregarded.
 Inattentive or incorrect handling and use of improper equipment
 Unauthorized modifications and repairs
 Insufficient installation and safeguarding of the machine
 Disregarding the installation requirements and conditions of use
 atmospheric discharges, overvoltage and lightning strokes as well as chemical influences
 The following items are also not subject to liability or warranty claims:
 Wearing parts and components which are subject to a standard wear as intended such as
e.g. V-belts, ball bearings, illuminants, filters, sealings, etc.
 Non reproducible software errors
 Any services, which OPTIMUM GmbH or one of its agents performs in order to fulfil any
additional warranty are neither an acceptance of the defects nor an acceptance of its
obligation to compensate. Such services neither delay nor interrupt the warranty period.
 Place of jurisdiction for legal disputes between businessmen is Bamberg.
 If one of the aforementioned agreements is totally or partially inoperative and/or invalid, a
provision closest to the intent of the warrantor is considered agreed upon, which remains
within the framework of the limits of liability and warranty which are specified by this
contract.
parts S275N double channel wiring 1.2.0
5.2 The correct saw band tension is reached when the saw
band has been tensioned in the green area of the pressure
gauge.
1.2.1
3 ; 4.10 ; 4.10.3 Interdepartmental transport ; General information
concerning saw bands
1.2.2
CE Update 1.2.3
5.2 Additional illustration and amended description "Adjusting
the position of the saw band".
1.2.4
Chapter Short note new version no.