Optimum 3300260 - Table of Contents

To Next Page

To Previous Page

Version 1.2.4 - 2022-10-262 Translation of original instruction

S275N | S275NV

S275N_S275NV_GBIVZ.fm

Table of contents

1 Safety

1.1 Type plates .................................................................................................................................................... 5

1.2 Safety instructions (warning notes)................................................................................................................ 6

1.2.1 Classification of hazards .................................................................................................................. 6

1.2.2 Other pictograms.............................................................................................................................. 6

1.3 Intended use.................................................................................................................................................. 7

1.4 Reasonably foreseeable misuse.................................................................................................................... 8

1.4.1 Avoiding misuse............................................................................................................................... 8

1.5 Possible dangers caused by the metal band saw.......................................................................................... 9

1.6 Qualification of personnel .............................................................................................................................. 9

1.6.1 Target group..................................................................................................................................... 9

1.6.2 Authorized personnel ..................................................................................................................... 10

1.7 Safety devices ............................................................................................................................................. 11

1.7.1 Emergency-stop button.................................................................................................................. 11

1.7.2 Saw arch ........................................................................................................................................ 11

1.7.3 Saw belt guide................................................................................................................................ 11

1.7.4 Prohibition, warning and mandatory signs ..................................................................................... 11

1.8 Safety check ................................................................................................................................................ 12

1.9 Personal protective equipment .................................................................................................................... 12

1.10 Safety during operation................................................................................................................................ 13

1.11 Safety during maintenance.......................................................................................................................... 13

1.11.1 Disconnecting and securing the metal band saw........................................................................... 13

1.11.2 Using lifting equipment................................................................................................................... 14

1.11.3 Mechanical maintenance work....................................................................................................... 14

1.12 Accident report............................................................................................................................................. 14

1.13 Electronics ................................................................................................................................................... 14

1.14 Inspection deadlines.................................................................................................................................... 15

2 Technical data

2.1 Emissions .................................................................................................................................................... 17

3 Delivery, interdepartmental transport, assembly and commissioning

3.1 Notes on transport, installation, commissioning .......................................................................................... 18

3.1.1 General risks during internal transport ........................................................................................... 18

3.2 Unpacking the machine ............................................................................................................................... 19

3.3 Requirements regarding the installation site................................................................................................ 19

3.4 Dimensions S275N │ S275NV ................................................................................................................... 20

3.5 Assembly ..................................................................................................................................................... 21

3.5.1 Assembling the machine stand - V1............................................................................................... 21

3.5.2 Assembling the machine stand - V2............................................................................................... 22

3.5.3 Fit optional levelling disc SE2 ........................................................................................................ 22

3.5.4 Load suspension point ................................................................................................................... 22

3.5.5 Drip pan.......................................................................................................................................... 24

3.5.6 Material stop................................................................................................................................... 24

3.6 Electrical connection.................................................................................................................................... 24

3.6.1 Electrical connection S275N .......................................................................................................... 24

3.6.2 Electrical connection S275NV........................................................................................................ 25

3.7 First commissioning..................................................................................................................................... 25

4Operation

4.1 Control and indicating elements .................................................................................................................. 27

4.2 Safety........................................................................................................................................................... 28

4.3 Inserting the workpiece................................................................................................................................ 28

4.4 Setting of angle cut...................................................................................................................................... 28

4.5 Adjusting the saw belt guide ........................................................................................................................ 29

4.6 Switching on the machine............................................................................................................................ 29

4.7 Switching off the machine............................................................................................................................ 29

4.8 Resetting an emergency stop condition....................................................................................................... 29

4.9 Adjusting the speed of the saw belt............................................................................................................. 29

4.9.1 Selector switch / speed controller .................................................................................................. 29

4.9.2 Saw belt speeds............................................................................................................................. 30