Optimum DX17V - 6 Appendix 6.1 Copyright; 6 Appendix; Liability Claims for Defects; Warranty; Terminology;Glossary

Page 34
DX17VGB
6 Appendix
6.1 Copyright
This document is protected by copyright. All derived rights are reserved, especially those of
translation, re-printing, use of figures, broadcast, reproduction by photo-mechanical or similar
means and recording in data processing systems, either partial or total.
Subject to technical changes without notice.
6.2 Terminology/Glossary
6.3 Liability Claims for Defects / Warranty
Bes
ide the legal liability claims for defects of the customer towards the seller, the manufacturer
of the product, company does not grant any further warranties unless they are listed below or
were promised in the framework of a sin-gle contractual provision.
The processing of the liability claims or of the warranty is performed as chosen by
c
ompany either directly or through one of its dealers.
Any defective products or components of such products will either be repaired or
replaced by components which are free from defects. Ownership of replaced
products or components is transferred to company.
 The automatically generated original proof of purchase which shows the date of purchase,
the type of machine and the serial number, if applicable, is the precondition in order to
assert liability or warranty claims. If the original proof of purchase is not presented, we are
not able to perform any services.
 Defects resulting from the following circumstances are excluded from liability and warranty
claims:
- Using the product beyond the technical options and proper use, in particular due to over-
straining of the machine.
- Any defects arising by one's own fault due to faulty operations or if the operating manual
is disregarded.
- Inattentive or incorrect handling and use of improper equipment
- Unauthorized modifications and repairs
- Insufficient installation and safeguarding of the machine
- Disregarding the installation requirements and conditions of use
- atmospheric discharges, overvoltage and lightning strokes as well as chemical influences
Term Explanation
Drill chuck Drill bit adapter
Drill head upper part of the drilling machine
Drill spindle Shaft activated by the motor
Drilling table Supporting surface, clamping surface
Taper mandrel Cone of the drill or of the drill chuck
Drilling lever Manual operation for the drill feed
Quick-action drill chuck drill holding fixture to be clamped manually.
Workpiece part to be drilled, part to be machined.
Tool Drill bit, countersink, screw tap
Emergency stop Stops the operation of a machine.
Emergency switching off Interrupts the power supply of the machine.