Page 6
DX17VGB
1.3 Intended use
WARNING!
In the event of improper use, the drilling machine
will endanger personnel,
will endanger the machine and other material property of the operating company,
the correct function of the drilling machine may be affected.
The drilling machine is designed and manufactured to be used in a non-explosive environment.
The drilling machine is designed and manufactured for holes in cold metals or other non flam-
mable materials or that not constitute a health hazard using a rotating filing-stripping tool that
has a number of groov
es for collecting the filings.
If the drill is used in any way other than described above or modified without the approval of
company, the drill is being used improperly.
We will not be held liable for any damages resulting from any operation which is not in accord-
ance with the intended use.
We expressly point out that the guarantee or CE conformity will expire due to any constructive
technical or procedural changes which had not been performed by the company.
It is also part of intended use that you
observe the limits of the drilling machine,
the operating manual is observed,
the inspection and maintenance instructions are observed.
"Technical specification“ on page 12
WARNING!
Extremely severe injuries.
It is forbidden to make any modifications or alternations to the operation values of the
drilling machine! They could endanger the personnel and cause damage to the drilling
machine.
INFORMATION
The control and drive components of the bench drilling machine are approved for industrial and
commercial use within industrial supply systems. Utilization in public supply systems requires
another configuration and/or additional measures.
Activation forbidden!
Use ear protection!
Read the operating instruc-
tions before commission-
ing!
Disconnect the mains plug!
Wear protective glasses! Wear protective gloves! Wear safety shoes! Wear a protective suit!
To Next Page
Loading...
