Version 1.0 dated 2019-01-08Page 54 Translation of the original instructions
B13 basic | B14 basic | B16 basicGB
B13-B14-B16_basic_GB.fm
OPTIMUM
MASCHINEN - GERMANY
®
5.1.2 Restarting
Before restarting, run a safety check.
WARNING!
Before starting the machine you must be sure that
no dangers generated for persons,
the machine is not damaged.
5.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. Any indicated intervals therefore are only valid for the corresponding approved con-
ditions.
Interval Where? What? How?
Start of work
and after each
maintenance
or repair work
Bench drill
"Safety check“ on page 39
weekly
Clamping bolts
V-belt tension
Check if the attachment screws for the V-belt tension on the
left and right side of the drilling head are well fastened.
Check if the V-belts are well tightened. Checking the tension
of V-belts,
"Speed variation“ on page 50.
Every month
Drilling column and
toothed rod
Oiling
Lubricate the drill column regularly with commercial oil.
Lubricate the toothed rod regularly with commercial grease
(e.g. friction bearing grease).
Every 6
months
V-belts at the drill head
Visual inspection
Check whether the V-belts have become porous and worn.
Img.5-1: V-belt housing
Every 6
months
Electronics
Testing
Check the electrical equipment / parts of the bench drill.
To Next Page
Loading...
Need help?
General