Safety
Version 2.1.1 - 2020-07-2712 Translation of original instruction
B40 GSP
EN
B40GSP_GB_1.fm
INFORMATION
The mains plug of the geared drill must be freely accessible.
1.8 Safety measures during operation
CAUTION!
Risk due to inhaling of health hazardous dusts and mist.
Dependent on the material which need to be processed and the used auxiliaries dusts
and mist may be caused which might impair you health.
Make sure that the generated health hazardous dusts and mist are safely sucked off at
the point of origin and is dissipated or filtered from the working area. To do so, use a
suitable extraction unit.
CAUTION!
Risk of fire and explosion by using flammable materials or cooling lubricants.
Before processing inflammable materials (e.g. aluminium, magnesium) or using
inflammable auxiliary materials (e.g. spirit) it is necessary to take additional preventive
measures in order to safely avoid health risks.
CAUTION!
Risk of winding-up or cutting damages when using hand tools.
The machine is not designed for the use of hand tools (e.g. emery cloth or files). It is
forbidden to use any hand tools on this machine.
1.9 Safety devices
Use the geared drill only with properly functioning safety devices.
Stop the geared drill immediately if there is a failure on the safety device or if it is not function-
ing for any reason.
It is your responsibility!
If a safety device has been activated or has failed, the geared drill must only be used if you
have removed the cause of the failure,
have verified that there is no danger resulting for the staff or objects.
WARNING!
If you bypass, remove or override a safety device in any other way, you are endangering
yourself and other persons working on the geared drill. The possible consequences are
injuries due to components or parts of components flying off at high speed,
contact with rotating parts,
fatal electrocution.
WARNING!
The separating protective equipment which is made available and delivered together
with the machine is designed to reduce the risk of workpieces or fractions of them which
being expelled, but not to remove them completely. Always work carefully and observe
the limit values of your chipping process.
The geared drill includes the following safety devices:
an EMERGENCY STOP push button,
a lockable main switch,
a drilling table with T-slots to fix the workpiece or a vice,
a drill chuck guard, in order to prevent interference with the rotating tool.
To Next Page
Loading...
Need help?
General