Maintenance
Version 2.1.1 - 2020-07-27 39Translation of original instruction
B40 GSP EN
B40GSP_GB_5.fm
6.1.1 Preparation
WARNING!
Only carry out work on the machine if it has been unplugged from the mains power
supply.
Disconnecting and securing the geared drill. on page 16
Attach a warning sign.
6.1.2 Restarting
Before restarting run a safety check.
Safety check on page 14
WARNING!
Before starting the machine you must be sure that
no dangers generated for persons,
the machine is not damaged.
6.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. For this reason, all the intervals are only valid for the authorised conditions.
Interval Where? What? How?
Start of shift
after every
maintenance
or repair work
Clean machine
Safety check on page 14
every day
Drill head
Lubricating
Lubricate the lubricating nipples on the lathe saddle.
Img.6-1: Lubricating nipple drill head
To Next Page
Loading...
Need help?
General