Version 2.1.1 - 2020-07-2726 Translation of original instruction
B40 GSP
EN
B40GSP_GB_3.fm
3.8.1 Checks
Check the geared drill as indicated under Safety check on page 14.
Check the geared drill as indicated under Oil level of the gear of the drilling spindle
sleeve on page 40.
3.9 Coolant pump
ATTENTION!
The coolant pump also delivers if it turns in the wrong direction. Due to the wrong
turning direction the pump is destroyed within a short time.
Img.3-4: Coolant pump, coolant filler hole
3.10 Warming up the machine
ATTENTION!
If the geared drill and in particular the drilling spindle is immediately operated at
maximum load when it is cold it may result in damages.
If the machine is cold, e.g. directly after having transported the machine, it should be warmed
up at a spindle speed of only 500 1/min for the first 30 minutes.
Coolant pump
Fill in coolant
To Next Page
Loading...
Need help?
General