Maintenance
Version 2.1.1 - 2020-07-2738 Translation of original instruction
B40 GSP
EN
B40GSP_GB_5.fm
6 Maintenance
In this chapter you will find important information about
Inspection
Maintenance
Repairs
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
operational safety,
failure-free operation,
long service life of the machine and
the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
ENVIRONMENTAL PROTECTION
During work on the spindle head, please make sure that
collector tanks are used with sufficient capacity for the amount of liquid to be col-
lected.
liquids and oils should not be split on the ground.
Clean up any spilt liquid or oils immediately using proper oil-absorption methods and dispose of
them in accordance with current legal requirements on the environment.
Collect leakages
Do not re-introduce liquids split outside the system during repair or as a result of leakage from
the reserve tank:collect them in a collecting container to be disposed of.
Disposal
Never dump oil or other substances which are harmful for the environment in water inlets, rivers
or channels.
Used oils must be delivered to a collection centre. Consult your supervisor if you do not know
where the collection centre is.
6.1 Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
very serious injury to personnel working on the machine,
damage to the machine.
Only qualified staff should carry out maintenance and repair work on the machine.
Validation
Check and maintain all safety-relevant stop, control and measuring devices (validation).
Documentation
Record all tests and works in a operator's log resp. log book.
To Next Page
Loading...
Need help?
General