Maintenance
Version 2.1.1 - 2020-07-2742 Translation of original instruction
B40 GSP
EN
B40GSP_GB_5.fm
First after 200
operatingm
hours, then
every 2000
operating
hours
Drill head
Changing the oil in the gear for the spindle sleeve feed
For oil change use an appropriate collecting tray of sufficient
capacity.
Unscrew the screw from the drain hole.
Img.6-6: Oil filling screw
Re-fills the gear of the spindle sleeve feed with gear oil.
Approx. consumption 0.5 litres.
Pay attention to the correct level.
Operating material on page 19
Img.6-7: Changing the oil in the gear for the spindle
sleeve feed
Every month
Drill column
and toothed rack
Lubricate
Oil the drilling column in regular intervals using standard oil.
Lubricate the rack regularly with commercial grease (e.g. fric-
tion bearing grease).
as required
Coolant equipment
Coolant pump
The coolant pump is maintenance-free.
Cooling lubricants and tanks on page 44
Inspection plan for water-mixed cooling lubricants on page 45
Rinse the coolant pump if you use coolants that leave residues.
Interval Where? What? How?
To Next Page
Loading...
Need help?
General