Malfunctions
Version 2.1.1 - 2020-07-2772 Translation of original instruction
B40 GSP
EN
B40GSP_GB_6.fm
Working spindle rattling on
rough piece surfaces
• Excessive slack in bearing
• Working spindle moves up and down
• Adjustment strip loose
• Clamping chuck is loose
• Tool is blunt
• Workpiece is loose
• Readjust bearing slack or replace
bearing
• Readjust bearing clearance (fixed
bearing)
• Adjust strip to the correct slack using
the adjusting screw
• Check, re-tighten.
• Sharpen or replace tool
• Clamp the workpiece firmly.
Malfunction Cause / possible effects Solution
To Next Page
Loading...
Need help?
General