Optimum Optimill BF 30V - Maintenance; 5.1 Safety; 5.1.1 Preparation; 5.1.2 Restarting

OPTIMUM
MASCHINEN - GERMANY
Maintenance
Version 1.1.5 dated 2015-08-31 Page 37Original operating instructions
BF30Vario GB
5 Maintenance
In this chapter you will find important information about
 Inspection
 Maintenance
 Repair
of the drilling-milling machine.
ATTENTION!
Properly performed regular maintenance is an essential prerequisite for
 operational safety,
 failure-free operation,
 long service life of the drilling-milling machine and
 the quality of the products which you manufacture.
Installations and equipment from other manufacturers must also be in good order and condition.
5.1 Safety
WARNING!
The consequences of incorrect maintenance and repair work may include:
 very serious injury to personnel working on the drilling-milling machine,
 damage to the drilling-milling machine.
Only qualified staff should carry out maintenance and repair work on the drilling-milling
machine.
5.1.1 Preparation
WARNING!
Only carry out work on the drilling-milling machine if it has been disconnected from the
mains power supply.
 "Switching-off and securing the drilling-milling machine“ on page 16
Attach a warning sign.
5.1.2 Restarting
Before restarting run a safety check.
 "Safety check“ on page 14
WARNING!
Before starting the drilling-milling machine, you must check that there is no danger for
persons and that the drilling-milling machine is not damaged.