OPTIMUM
MASCHINEN - GERMANY
Maintenance
Version 1.1.5 dated 2015-08-31Page 38 Original operating instructions
BF30VarioGB
5.2 Inspection and maintenance
The type and level of wear depends to a large extent on the individual usage and operating
conditions. For this reason, all the intervals are only valid for the authorised conditions.
Interval Where? What? How?
Start of work,
after every
maintenance
or repair work
Drilling-milling machine
"Safety check“ on page 14
Start of work,
after every
maintenance
or repair work
Dovetail guides
Oiling
Lubricate all slideways.
Every week
Cross table
Oiling
Oil all bare steel surfaces. Use an acid-free oil, e.g.
weapon oil or motor oil.
Every week
Gear milling head
Oil level
Check the oil level of the gear. The oil level must be in the
middle of the view glass.
Img.5-1: Oil sight glass speed gear
To Next Page
Loading...
