6 © Hypercom EMEA Ltd. 2011
How to clean your terminal
WARNING: DO NOT USE UNDILUTED AMMONIA OR ABRASIVE CLEANERS
Switch off and unplug the mains Power Supply units from the Terminal and
AP100/110/210 Access Point and D4200 Charging Dock station if applica-
ble. Carefully note how all the cables are connected and then disconnect
all cables before cleaning.
Apply denatured alcohol (methylated spirits) to a clean, soft, non-abrasive,
low-lint cloth. Carefully wipe the entire Terminal and Access Point.
Use an air duster (compressed air) to clean in and around the printer
mechanism.
To Next Page
Loading...