Other CRUs
Removal and Replacement 3-13
To Perform a Forced Power-Down
1. Quiesce the host application to prevent disruption of active storage operations.
2. (Optional) Enable the locate library indicator (see "To Enable the Locate Light" on
page 3-3).
3. Find the rack containing the library you want to power down.
4. Remove power from the library using one of the following methods:
a. Use the forced (hard) shutdown method. Press the front panel power button
and hold it until the library shuts down (approximately 10 seconds).
b. (Optional) Use the physical method, if the hard shutdown does not work.
Remove power from all power supplies (disconnect the power cord from all
power supplies or set the PDU or power strip switch to the off position).
To Remove a Cartridge Magazine Manually
Caution: Manual removal of a tape cartridge magazine can
damage the robotic mechanism. This procedure supports removal
and replacement for some CRUs listed in "Other CRUs" on
page 3-11. Power down the library before beginning this procedure.
Task 1 Release the Magazine Latch
1. Power down the library (see "Power-Down" on page 3-11).
2. Insert the hex key, provided in the installation kit, into the access hole at the lower
inside corner of the cartridge magazine.
3. Align the hex key parallel to the magazine face (see Figure 3–13).
4. Push the tool slowly into the access hole to engage the latch located behind the
touch screen, and hold the hex key in place.
Figure 3–13 Magazine Release
To Next Page
Loading...
