Mode Select Command
August 2016 Commands 99
LBP_W
Logical Blocks Protected during
0 = Protection Information is not included with the data
transferred when writing.
1 = Protection Information is included with the data transferred
when writing.
Notes:
• If the Logical Block Protection Method field is set to zero,
the LBP_W bit is set to zero.
• If Logical Block Protection Method field is set to a non-zero,
then one or more of LBP_W or LBP_R bits must be set to a
non-zero.
LBP_R:
Logical Blocks Protected Read
0 = Protection Information is not included with the data
transferred when reading.
1 = Protection Information is included with the data transferred
when reading.
Notes:
If the Logical Block Protection Method field is set to zero, the
LBP_R bit is set to zero.
If the Logical Block Protection Method field is set to a non-zero
then one or more of LBP_W or LBP_R bits must be set to a non-
zero.
RBDP:
Recover Buffered Data Protected
0 = Protection Information is not included with the data
transferred by the Recover Buffered Data command.
1 = Protection Information is included with the data transferred
by the Recover Buffered Data command. (This bit is Ignored).
Notes:
• If the Logical Block Protection Method field is set to zero,
the RBDP bit is set to zero.
• If Logical Block Protection Method field is set to a non-zero
then this bit is ignored.
Parameter Value
To Next Page
Loading...
Need help?
General