EasyManuals Logo
Home>Oracle>Storage>StorageTek T10000

Oracle StorageTek T10000 User Manual

Oracle StorageTek T10000
132 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #58 background imageLoading...
Page #58 background image
View or Change Configuration Settings
4-4 StorageTek T10000 Tape Drive Operator's Guide
Intf FICON
which enables the drive interface to run FICON protocol.
Defaults to the last saved selection.
In the online (view) mode, the current interface selection appears. You must switch to
the offline (change) mode to toggle the selection.
Procedure:
Do one of the following actions:
Press Menu (No) to bypass.
Press Select (offline) until desired option appears; then, press Menu to set and
initiate an IPL to load the desired firmware modules.
Note: Manufacturing ships drive FRUs with the
Intf FCP
option
selected. When a defective drive in a FICON interface is replaced,
you must change the selection to
Intf FICON
. After IPL is complete,
the menu system displays the appropriate FICON related items.
Port A Attributes Menu
The operator panel window shows either
View PrtA ? (online)
or
Cfg PrtA ?
(offline).
Procedure:
Press Menu (No) to bypass or press Select (Yes) to enter submenus.
View or configure port attributes as defined in the following submenus.
Port A/B 24-Bit Address Identifier Submenu
The submenu is present when the drive is in the online state.
A=xxyyzzan or
B=xxyyzzan
24-bit (6 hexadecimal characters) port identifier at
interface log on, plus connection type and speed.
xx = domain (00 in private loop or point-to-point)
yy = area (00 in private loop or point-to-point)
zz = 00 - EF (per connection type)
a = connection type (f: fabric, n: point-to-point, 0: public loop, v: private loop)
n = connection speed (varies by tape drive model)
A=........
or
B=........
appears when the port is not logged onto an interface
Procedure:
Press Menu or Select to advance to the next submenu.
Port A/B SFP Module Parameter Submenu
Shows the Small Form-factor Pluggable (SFP) module information.
Note: Display is information only and appears in both online and
offline menus.
Operator panel window shows:
nnGMM0nnnm
,
nnGSRnnnm
,or
nnGSMnn.nk
.
Appears when an SFP module is present and readable:

Table of Contents

Other manuals for Oracle StorageTek T10000

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Oracle StorageTek T10000 and is the answer not in the manual?

Oracle StorageTek T10000 Specifications

General IconGeneral
BrandOracle
ModelStorageTek T10000
CategoryStorage
LanguageEnglish

Related product manuals