View or Change Configuration Settings
4-12 StorageTek T10000 Tape Drive Operator's Guide
TapeBar N
disables the option.
Procedure:
■ Do one of the following actions:
– Press Menu to bypass.
– Press Select to toggle; then, press Menu to set and advance to the next
submenu.
Library Address Submenu
Note: Manufacturing ships drives with
Lib Adr FF
selected.
The operator panel window shows
Lib Adr xy
.
■ For SL8500, SL3000, and L180/L700/L1400 libraries; use the factory preset
(FF)
with T10000 tape drives.
■ In 9310 libraries (T10000A only), looking at the back of the drives, the address
sequence in the drive cabinet is:
Left column from top: 00 through 09.
Right column from top: 0A through 13.
Defaults to the last saved selection.
Procedure:
1. Do one of the following actions:
a. Press Menu to bypass.
b. Press Select to start the change mode.
2. Press Select to increment the x digit until the desired value appears, then press
Menu to set.
3. Repeat step 2 for the y digit.
4. Press Menu to advance to the next submenu; or, press Select to restart the change
mode.
StorageTek File Sync Accelerator Submenu
Note: Manufacturing ships drives with
SFileAcelY
selected.
SFileAcelY
selects file sync accelerator. enables applications to reduce or eliminate
back hitches caused by writing a tape mark or other sync operations.
SFileAcelN
deselects file sync accelerator.
Defaults to the last saved selection.
Procedure:
■ Do one of the following actions:
– Press Menu to bypass.
To Next Page
Loading...
