Replacing a ZS3-2 HDD or SSD
6.
Grasp the release lever and pull the drive out of the drive slot.
7.
After at least 30 seconds, navigate to the Hardware > Maintenance screen, and
click the right-arrow icon on the system controller to verify that the software
has detected that the drive is not present.
8.
Align the replacement drive with the drive slot.
9.
Press on the release button to slide the drive into the chassis until the release
lever moves slightly inward.
132 Oracle ZFS Storage Appliance Customer Service Manual • July 2016
To Next Page
Loading...
Need help?
General