Oriental motor BLVM620K-GFS - Motor and Driver Connection Procedures

Connection
−25−

Applicable crimp terminal
When crimp terminals are used, select the following products to use.
Manufacturer Part number Applicable lead wire
PHOENIX CONTACT GmbH & Co. KG
AI 1,5-10 AWG 16 (1.25 mm
2
)
AI 2,5-10 AWG 14 (2 mm
2
)
AI 4-10 AWG 12 (3.5 mm
2
)

Recommended power supply capacity
Model Input power supply voltage Power supply capacity
BLV510
24 VDC±10% 400 W or higher
BLV620
24 VDC±10% 800 W or higher
BLV640
48 VDC±10% 1 kW or higher
7.2 Connecting the motor and driver
Connect the motor power connector and the motor signal connector to the CN2 and the CN3 on the driver,
respectively.
When using an electromagnetic brake type product, connect the electromagnetic brake connector to the CN8.
For the
BLV510
product, the connection cable (included) is required to connect the motor and driver.
•
Maximum extension distance between the motor and driver
BLV510
: 1.5 m (4.9 ft.) [including 0.5 m (1.6 ft.) of motor cable]
BLV620
,
BLV640
: 3.5 m (11.5 ft.) [including 0.5 m (1.6 ft.) of motor cable]
Motor power connector
Connect to CN2
Motor signal connector
Connect to CN3
Electromagnetic brake connecto
r
Connect to CN8∗
∗*
Electromagnetic brake type only
Note
Make sure the connector is inserted securely. Insecure connection may cause malfunction or damage to the
motor or driver.