Operation
−31−
8 Operation
This chapter explains the operations that can be performed with the
BLV
Series.
8.1 Operation overview
With the
BLV
Series, in addition to the basic operation, the extended operation using the
MEXE02
,
OPX-2A
, or
RS-485 communication can be performed.
The table below shows the details of each operation and the reference pages.
Operation types What you can do Description Ref.
Basic operation
Speed
setting
Internal
potentiometer
Sets the speed using the internal potentiometer.
P.32External
potentiometer
Sets the speed using the external potentiometer.
External DC voltage Sets the speed using an external DC voltage.
Operation and stop Operates or stops the motor. P.33
Setting the acceleration time and
deceleration time
The acceleration time and deceleration time for
starting and stopping can be set.
P.34
Two-speed operation
Operation can be performed at two speeds through
use of both the external potentiometer (external DC
voltage) and internal potentiometer.
P.35
Examples of operating patterns
Examples of operation and stop are explained using
timing charts.
P.36
Multi-motor control
A single external potentiometer (external DC voltage)
can be used to set the same speed for multiple motors.
P.39
Function
Speed response
selection
Selects the motor response in reaction to the
command speed.
P.35
Torque limiting
function
The output torque of the motor can be limited. P.36
Sink logic/Source logic
selection
Switches the input circuit between sink logic and
source logic.
P.37
Extended operation
Using the support software
MEXE02
or the data setter
OPX-2A
(sold separately) can extend
functions such as the digital setting of the rotation speed and torque limiting value, the
setting of parameters, and various monitors.
P.40
Control via RS-485
communication
Modbus protocol can be used in RS-485 communication.
Refer to the USER MANUAL (RS-485 Communication Mode) for details.
−
Control via CC-Link
communication
Using the network converter
NETC01-CC
, operation via CC-Link communication can be
performed.
Refer to the operating manual of the network converter for details.
−
Control via
MECHATROLINK
communications
Using the network converter
NETC01-M2
or
NETC01-M3
, operation via MECHATROLINK
communications can be performed.
Refer to the operating manual of the network converter for details.
−
Control via EtherCAT
communication
Using the network converter
NETC01-ECT
, operation via EtherCAT communication can be
performed.
Refer to the operating manual of the network converter for details.
−
To Next Page
Loading...
