Safety precautions
−5−
•
Do not use the motor, gearhead and driver beyond the specications. Doing so may result in electric shock, injury
or equipment damage.
•
Keep your ngers and objects out of the openings in the driver. Failure to do so may result in re, electric shock or
injury.
•
Do not touch the motor, gearhead or driver while operating or immediately after stopping. The surface of the
motor, gearhead or driver may be hot and cause a skin burn(s).
•
Do not leave anything around the motor and driver that would obstruct ventilation. Doing so may result in
damage to equipment.
•
Do not move the product by holding the output shaft of the motor or the gearhead, or the motor cable. Doing so
may result in injury.
•
Do not touch the motor output shaft (key slot or pinion) with bare hands. Doing so may result in injury.
•
When assembling the motor with the gearhead, exercise caution not to pinch your ngers or other parts of your
body between the motor and gearhead. Injury may result.
•
When installing the motor or gearhead in the equipment, exercise caution not to pinch your ngers or other parts
of your body between the equipment and motor or gearhead. Injury may result.
•
Do not shut o the negative side of the power supply during operation. Also, make sure that the wiring for the
power supply does not disconnect. This may result in damage to equipment.
•
Do not touch the rotating part (output shaft) while operating the motor. Doing so may cause injury.
•
Securely install the motor, gearhead and driver to their respective mounting plates. Inappropriate installation
may cause the motor, gearhead or driver to detach and fall, resulting in injury or equipment damage.
•
Provide a cover over the rotating part (output shaft) of the motor or gearhead. Failure to do so may result in injury.
•
Securely install a load on the output shaft of the motor or gearhead. Inappropriate installation may result in injury.
•
Provide an emergency stop device or emergency stop circuit external to the equipment so that the entire
equipment will operate safely in the event of a system failure or malfunction. Failure to do so may cause injury.
•
Immediately when a problem occurred, stop operation and turn o the driver power. Failure to do so may result
in re, electric shock or injury.
•
The motor surface temperature may exceed 70°C (158°F) even under normal operating conditions.
If the operator is allowed to approach the motor in operation, attach a warning label in a
conspicuous position as shown in the gure. Failure to do so may result in a skin burn(s).
Warning label
To Next Page
Loading...
