Oriental motor BLVM620K-GFS - Page 57

Setting contents of MEXE02
−57−
Example)
When the pulley diameter is 0.1 m and the gear ratio of the gearhead is 20
≅
63.7Co
nveyor speed reduction ratio =
Gearhead gear ratio
Pulley diameter [m] × π
=
20
0.1
［
m
］
× π
From the conversion formula, the conveyor speed reduction ratio is calculated as 63.7 in this example.
If the conveyor speed reduction ratio is 63.7 and the rotation speed of the motor is 1300 r/min, the conveyor
transfer speed is converted as follows:
≅
20.4
1300
63.7
Co
nveyor transfer speed [m/min] =
[
MEXE02
Status monitor window]

"Motor rotation direction selection" parameter
Even when a gearhead with a reduction ratio which rotation direction is opposite to the motor output shaft is used,
the rotation direction of the gearhead output shaft when the input signal is turned ON can be set to the same as that
of the motor.
Rotation direction of the motor output shaft
⇒
p.34
•
2-Wire mode
Input signal
Rotation direction when the input signal is turned ON
"Motor rotation direction selection" parameter
Positive direction=CW Positive direction=CCW
FWD
CW
CC
W
•
3-Wire mode
Input signal
Rotation direction when the input signal is turned ON
"Motor rotation direction selection" parameter
Positive direction=CW Positive direction=CCW
FWD/REV
CC
W
CW