Installation
−9−
Installation method
Mounting to DIN rail
Use a DIN rail 35 mm (1.38 in.) wide to mount the speed
controller.
Pull down the DIN lever of the speed controller until it
locks, and push in the speed controller with hanging the
hook at the rear to the DIN rail, and then lift the DIN lever.
After installation, secure the both sides of the speed
controller with the end plate that the customer provides.
Hook
DIN rail
DIN lever
End plate
Removing from DIN rail
Pull the DIN lever down until it locks using a at tip
screwdriver, and lift the bottom of the speed controller to
remove it from the rail.
Use force of about 10 to 20 N (2.2 to 4.5 lb.) to pull the DIN
lever down.
Excessive force may damage the DIN lever.
Installing with screws
Install the speed controller through the mounting holes using two screws (M4: not included).
Tightening torque: 0.7 N·m (6.1 lb-in)
Use screws and washers, which sizes are Ø10 mm (0.39 in.) or less, to secure the speed controller.
111 mm (4.37 in.)
Mounting hole
Pull the levers
Mounting hole
Levers
When installing with screws, pull up and down the upper
and lower levers on the rear side of the speed controller
respectively before doing so.
Dimension
[Unit: mm (in.)]
Mass: 0.2 kg (0.44 lb.)
4 (0.16)
4 (0.16)
[5.5 (0.22)]
100 (3.94)
35 (1.38)
70 (2.76)
4 (0.16)
20 max.
(0.79 max.)
17.5 (0.69)
35.1
(1.38)
R2.25
(0.09)
ϕ
4.5 (
ϕ
0.177) Thru
111
±
0.5
(4.37
±
0.02
)
120.5 max. (4.74 max.)
[4.5
(0.18)]
DIN Installation Screw Installation
Slits
To Next Page
Loading...
