Orion Machine Manual
Revision 3.0 Flex Stretchwrapper
15 February 2016 System Operation
Page 3-25
BRUSH EXTEND DELAY
Press this button to modify the Brush Extend Delay value, in terms of milliseconds.
This value determines the amount of time, after the Brush and Cutter arm has begun
to extend, that the Brush will delay before extending to wipe the film tail against the
load. Min - 0 ms Max - 5000 ms
HOT WIRE ON DELAY
Press this button to modify the Hot Wire On Delay value, in terms of milliseconds.
This value determines the amount of time, after the Brush and Cutter arm has begun
to extend, that the Hot Wire will delay before turning on to cut the film. Min - 0 ms
Max - 5000 ms
HOT WIRE CUT
DURATION
Press this button to modify the Hot Wire Cut Duration value, in terms of millisec-
onds. This value determines the amount of time, after the Hot Wire has turned on,
that it will remain on to cut the film.
Warning: too high of a value may destroy the hot wire. Min - 1000 ms Max - 7000
ms
Table 3-16. The Timers Screen Button Descriptions (Continued)
STATE 1 DESCRIPTION
To Next Page
Loading...
Need help?
General
