Orion FLEX RTD User Manual

Machine Manual Orion
Flex Stretchwrapper Revision 3.0
System Operation 15 February 2016
Page 3-26
Machine Setup Screen
This is the Machine Setup Screen. This screen is used when setting up the initial machine
configuration. The technicians who assembled you machine already set the type of
machine you have on this screen. You will not need to make any changes on this screen in
day-to-day use.
Figure 3 - 18
The Machine Setup
Screen
Table 3-17. The Machine Setup Screen Button Descriptions
STATE 1 DESCRIPTION STATE 2
SELECT A MODEL Press this button to select model A. A MODEL SELECTED
SELECT D MODEL Press this button to select model D. D MODEL SELECTED
SELECT S MODEL
Press this button to select model S. If S is selected
and the machine is actually an A or a D model, the
revologic tooth counting is de-activated.
S MODEL SELECTED
SELECT TURNTABLE
Press this button to select that the machine is a turn-
table machine.
TURNTABLE
SELECTED
SELECT ROTARY ARM
Press this button to select that the machine is a
rotary arm machine.
ROTARY ARM
SELECTED
INSTA-CUT DISABLED
Press this button to activate or de-activate Insta-
Cut.
INSTA-CUT ENABLED
PRESS FOR 96 TOOTH
SPROCKET
Press this button to select whether the machine has
a 96 tooth or a 112 tooth sprocket.
PRESS FOR 112 TOOTH
SPROCKET

Orion FLEX RTD Specifications

General

Brand	Orion
Model	FLEX RTD
Category	Stretch Wrapping Systems
Language	English