ww.teamorion.com 21
example). With the stock motor software, boost timing
and turbo timing can be eective simultaneously. With the
modied motor software, boost timing is applied in totality
before the turbo timing added. Turbo timing is meant to
increase top speed down the straight sections of the track.
› Setting range:
modied from 0° to 20° in 1° steps
stock from 0° to 40° in 1° steps
14. Turbo Slope Rate
This setting adjusts how fast the turbo timing is applied
while you are at full throttle. For example if the setting is
6°/0.1s and the turbo setting is 24deg, you will have to be
at full throttle for 0.4 seconds (6x4=24) for the full turbo
timing to be applied. A higher setting will provide stronger
acceleration but will also increase the heat generation.
› Setting range:
from 3°/0.1s to Instantaneous
15. Turbo Delay
This adjusts how long you have to be at full throttle before
the turbo timing is applied.
› Setting range:
from 0 to 0.8 seconds in 0.1second steps
Note : The total max timing is 64deg (boost + turbo). If the
total timing value setting is higher than 64deg, only 64deg
will be applied. For example if boost is 64deg and turbo is
20deg, only the boost timing will be eective (similar to if the
turbo setting was 0deg).
To Next Page
Loading...
