IG-273-EN version 03; 05/08/2020
17
General instructions
cpg.0 ENA range
Installation
6. Installation
6.1. Unpacking the equipment
The cpg.0 switchgear is supplied protected with a plastic
cover.
On receiving the equipment, check that the goods
supplied correspond to the order and associated
documentation. If this is not the case, contact
Ormazabal immediately.
The disassembly process for the equipment is as follows:
1. Using a blade, cutter or similar tool, cut the lm
packaging the cubicle is wrapped in.
2. Remove the lm wrapping.
3. Detach the white polystyrene corner pieces.
4. Unscrew the xings between the base and the pallet.
5. Dispose of any waste in an environmentally-friendly
manner.
It is advisable to make a visual inspection of the equipment
to check whether it has suered any damage in transit. If
damaged, contact Ormazabal immediately.
To Next Page
Loading...
Need help?
General
