OTARI MX-55T-M - Set Button

MX-55 Operation Manual
Controls and Indicators
[3J SET button Pressing this button initiates Set mode. There are three Set modes:
A. Cue Point Set mode: In which a desired tape time can be
entered and stored in any selected Cue Point memory.
B. Varl Speed Set mode: In which the amount of pitch change
from the nominal tape speed can be preset.
C. VEM Set mode: In which the amount of speed change from
the nominal VEM tape speed can be preset.
When Set mode has been selected, the decimal pOints of the Tape
Time display flash, and the functions of the buttons associated
with the Tape Time display are changed as follows:
• SEARCH ZERO: In Cue Point Set mode, pressing this button alternates, in turn,
between 0, 1,2, and - time entry.
In Vari Speed Set mode, pressing this button alternates between + (no display)
and - percentage entry.
In VEM Set mode, pressing this button alternates between 0 (no display) and 1
(corresponding to 100%).
• SEARCH 1: In Cue Point Set mode, pressing this button increments the hours
digit by one.
In Vari Speed Set mode, pressing this button alternates, in turn, between 0,1,
and 2 (corresponding to tens of percent of speed change) .
In VEM Set mo:le, pressing this butt on increments the tens of percent digit.
• SEARCH 2: In Cue Point Set mode, pressing this button increments the tens
of minutes digit by one.
In Vari Speed Set mode, pressing this button increments the units of percent digit
by one.
In VEM Set mode , pressing this button increments the units of percent digit.
• SEARCH 3: In Cue Point Set mode, pressing this button increments the units of
minutes digit by one.
In Vari Speed Set mode, pressing this button increments the tenths of percent
digit by one.
In VEM Set mode, pressing this button increments the tenths of percent digit.
• REPEAT: I n Cue Point Set mode, pressing this button increments the tens of
seconds digit by one.
In Vari Speed Set mode, pressing this button increments the hundredths of
percent digit by one .
In VEM Set mode, pressing this button increments the hundredths of percent digit.
• CLR: I n Cue Point Set mode, pressing this button increments the units of
seconds digit by one .
In Vari Speed Set and VEM Set modes, pressing this button has no effect.
March 1989
2-5