OTARI MX-55T-M - Repeat Button; CLR Button

Controls and Indicators
MX-55 Operation Manual
If Switches 2-1 or 2-2 (on the Transport Control PCB) are On, the
function of the SEARCH 3 button is changed to Fader Start, Search
Start, or Foil Sense On/Off. Refer to Section 5.3 for further
information.
[8] REPEAT button
[9] CLR button
Pressing this button, then pressing any two illuminated SEARCH
buttons, or an illuminated SEARCH button and the SEARCH ZERO
button, then pressing PLAY button causes the MX-55 to enter
Repeat mode. In Repeat mode the machine plays from one select-
ed point to another, rewinds to the first point and plays again,
repeating until stopped. The indicators in the selected SEARCH
buttons will flash during Repeat mode and the indicator in the
REPEAT button is illuminated.
Pressing the REWIND or FAST FORWARD button during Repeat
mode causes the MX-55 to wind the tape to the corresponding Cue
Point and Stop. In Repeat mode, the tape cannot be moved beyond
the Cue Points.
To exit from Repeat mode, hold the CLR button pressed and press
the REPEAT button.
Pressing the REPEAT button again during Repeat mode causes the
REPEAT button indIcator to flash and the indicator in the selected
SEARCH button to become illuminated. In this mode, new cue
pOints can be selected for the Repeat operation without l eaving
Repeat mode.
Pressing this button together with another button cancels or resets
the mode associated with that button.
CLR + SET - deactivates Set mode.
CLR + TIME·IPS·% - resets the Tape Timer display to 0. 00.00.
CLR + SEARCH 1-3
- clears stored Cue Point memory.
CLR + REPEAT
- deactivates Repeat mode.
If SW 1-4 on the Transport Control PCB is On, pressing the CLR
button simultaneously with the SPEED H/L button changes the Tape
Speed.
2-8
March 1989