Displayed in the Collection window are:
• Test Type – name of test for which data has been collected
• ElapsedTime – duration of the test
(Also, the test date and time is displayed).
• Frame Rate – frequency of data acquisition in frames per second (fps)
• Calibration ∆ – the distance in pixels between the right and left eye positions measured during calibration
A. Test Type
B. Elapsed Time
C. Frame Rate
D. Calibration ∆
The system automatically stops when the maximum test duration is reached. To stop the test early, click Stop or press the
right button on the presentation remote. Data will be saved. To stop the test early, without saving data, click Cancel. (The
maximum test duration is set in Test Options.)
The data is analyzed and displayed in the Analysis window.
8.14 Skew Deviation data analysis
To view a specific test, click on the Test window tab and then click the desired test to highlight it. For more information
about selecting the test, refer to Selecting a test ► 12.
Analysis of the test results can be viewed in the Analysis window.
• To enlarge one window within the group, click the small box in the top right corner of that window.
• To return to the normal viewing mode, click the two overlapping boxes in the enlarged window.
For more information about switching between viewing modes (normal mode or enlarged mode), refer to the Reference
Manual.
Otometrics - ICS Impulse USB
41
8 Oculomotor
To Next Page
Loading...
