46
Pull the back padding (Fig. 5) with its cap over the back insert and close the zipper. Pull the
excess back padding down between the seat and lower edge of the back and attach it to the
corresponding snap fasteners on the outside of the back (Fig. 6).
Place the seat padding (Fig. 7) onto the seat so that the corresponding hook & loop straps are
connected. Allow the seat padding to extend approx. 2 cm over the back of the seat edge.
Information!
We recommend adjusting the seating unit as directed before mounting the padding
(please refer to section 4.1: “Adjustment and Adaptation Possibilities of the Seating
Unit”).
5
6
7
To Next Page
Loading...
Need help?
General
