61
NIRA Internal
fault code
J1939
SPN
J1939
FMI
Description
148 Trim position pump - Control error
150 100 1 Engine oil pressure - Data valid but below normal operational range
151 651 5 Fuel injector 1, Cylinder 1 - Open curcuit
152 652 5 Fuel injector 2, Cylinder 2 - Open curcuit
153 653 5 Fuel injector 3, Cylinder 3 - Open curcuit
154 654 5 Fuel injector 4, Cylinder 4 - Open curcuit
159 DG_FNO_GEAR_POSITION_FAULT
166 Fuel pump relay - Electrical fault
167 Trolling valve - Electrical fault
174 Hydraulic oil pressure - Data valid but above normal operational range
175 Hydraulic oil pressure - Data valid but below normal operational range
176 Hydraulic oil temperature - Data valid but above normal operational range
177 DG_FNO_OIL_LEVEL_LOW
179 97 31 DG_FNO_WATER_IN_FUEL
188 110 0 DG_FNO_COOLANT_TEMPERATURE
189 1136 0 DG_FNO_ECU_TEMPERATURE
190 175 0 DG_FNO_OIL_TEMPERATURE
191 2899 12 DG_FNO_GPC_MODULE
192 5324 31 DG_FNO_GPC_MODULE
193 DG_FNO_GPC_MODULE_COM
194 2433 2433 Exhaust gas temperature - Data valid but above normal operational range
196 171 171 Ambiant air temperature - Data valid but above normal operational range
198 107 107 Air filter pressure sensor - Data valid but below normal operational range
199 DG_FNO_COOLANT_LEVEL_LOW
200 Control head CAN RX time-out
To Next Page
Loading...
