PACOM SmartIP-8SD - Page 43

Part 3 - Conguration
43
Monitoring Options
System
Dene monitoring times. If self-diagnosis is not performed on a regular basis, the system
will assume an error.
Bootup, Restart,
Shutdown
Dene bootup, restart and shutdown actions.
Panic Record Dene panic recording actions.
Check Recording
The system will assume an error if the system has been scheduled to record normally but
recording does not take place during scheduled intervals.
Select Schedule On and then congure the days of the week, times, and monitoring interval.
Select the
button on the bottom left of the screen to add a schedule. Select icon to
delete the schedule.
Check Alarm-In
The system will assume an error if the alarm-in status does not change during the
specied monitoring interval while alarm-in is active.
Disk Almost Full Generates an event if the disk reaches the specied capacity (80% to 99%).
Disk Full Generates an event when all disks reach their maximum capacity.
Disk Bad
Generates an event when the specied percentage of the disk becomes damaged. Set to
between 10% and 90% in 10% intervals.
Disk Temperature
Specify the threshold temperature. Once any disk reaches this threshold, the system will
issue an alert.
Disk S.M.A.R.T.
Monitors disks that support S.M.A.R.T. and noties the user if a disk error is detected.
Fan Error Noties the user when the fan inside the system malfunctions.
eSATA Disconnected Noties the user if an eSATA device becomes disconnected while in use.
Disk Cong Change It will be highlighted when the NVR reboots after the hard disk drive has been replaced.
No Storage Found It will be highlighted when no hard disk drive has been connected.
t For system events, only an e-mail notication of actions can be selected.
t In order to use the Notify(Callback) feature, the NVR must be registered to the remote program on the receiving PC's end.