PACOM SmartIP-8SD - Monitoring System Status

Part 3 - Conguration
42
– Resync: Once you start mirroring, the two disks
will be resynchronized, which means that all data
on the destination disk will be erased and the data
on the source disk will be copied to the destination
disk. Select Resync option, designate the source
disk, and then click OK. When you click OK, all
data on the destination disk will be erased. After
resynchronization is complete, mirroring will start.
When you try resynchronizing, the disk that has never
tried mirroring cannot be selected as the source disk.
Once you start mirroring, all data on the destination
disk that designate as the source disk will be erased.
Please be careful not to designate the wrong disk by
mistake.
t Information: Indicates if the installed disk is being
used for mirroring or Resync purposes. Select
information about mirroring to check the disk’s model
and serial number.
Monitoring
Use this option to congure Monitoring settings.
t Settings: Congure when and what the system
should monitor for.
t Actions: Congure alarm-out (NVR alarm-out channel,
NVR beep, camera alarm-out channel) and notication
(email, LAN1 through 5, SNS, alert window) settings.