W7x User Manual
11
Power using PoE Injector
Switch
PoE Injector
Ethernet
Power &
Ethernet
W7
Power using PoE Switch
The W7x can be configured in Client Bridge, Repeater, or Access Point mode. When shipped from the factory, the
W7x is set to Access Point mode. The default IP address of the W7x is 192.168.1.250 and username/password of
pakedge / pakedgea
In order to log in to the W7x, you must first configure the TCP/IP settings of your PC/Notebook. Follow these steps:
1. Under “Control Panel”, double-click “Network Connections” and double-click the connection of
your Network Interface Card (NIC). The Local Area Connection Properties dialog appears:
To Next Page
Loading...
