W7x User Manual
33
Data Rate: From the drop-down list, choose the data transmission rate for the device (It is set to Auto by
default.)
Transmit Power: The power needed depends on the distance of the devices in your wireless
network. From the drop-down list, select the desired power. You can use this feature to limit the
coverage area of the wireless network.
RTS/CTS Threshold: Type the packet size threshold for RTS/CTS (Request to Send/Clear to send) to occur.
CLIENT LIST
The Client List menu appears only when the W7x is operating under Access Point mode or repeater mode. This
menu will show all the devices connected to the W7x. From the Client List, you can click on “Block” and this will
prevent the device from connecting.
NOTE: If you want to block a device from connecting on both the 2.4GHz and 5GHz band, then you must click on
“Block” under both the 2.4GHz and 5GHz client list.
CLIENT BRIDGE MODE
NOTE: The options in the main menu of the W7x change depending on the current operating mode of the
W7x. The main menu options discussed in this section are those available in Client Bridge mode.
To Next Page
Loading...
