Pakedge Device & Software W7 SERIES - Device Properties and Administration; Device Properties Configuration; Administration Settings

W7x User Manual
18
PROPERTIES
Under the System section in the W7x main menu, click “Properties”. The Properties page is where you can
specify a name for the device, choose the country of operation, and switch the W7x’s operating mode.
 Name: Type a name for the device. (Note: This name is not used as the device SSID.)
 Country: Select a country from the drop-down list.
 Mode: Select an operating mode. (For detailed information on configuring operating modes, see the
chapter on Mode-Specific Setup.)
 To save your changes, click “Apply”.
NOTE: For any changes to take effect, you must click the “Save Changes” button on the lower left below the menu.
This will reboot the access point, applying the configuration changes.
ADMINISTRATION
Click “Administration” under the System group in the W7x main menu. The Administration page allows
you to specify a user name and password for the W7x. By default, the W7x is configured with a default name of
pakedge and a default password of pakedgea. For security reasons, it is imperative to change the default user
name and password.