W7x User Manual
46
DIAGNOSTICS
If you experience network errors or unresponsive devices, the W7x diagnostic functions can help you determine
the cause. To access the diagnostic functions, on the W7x main menu, in the Log & Management section, click
Diagnostics. The Diagnostics page appears.
PING TEST PARAMETERS
Target IP: Type the IP Address of the device to check.
Ping Packet Size: Type the size of the ping packets (In Bytes).
Number of Pings: Type the number of ping attempts.
Click Start Ping to start the test.
TRACEROUTE TEST PARAMETERS
A Traceroute test can help you identify obstacles you may have in the network. The Traceroute text maps the path
that packets take between the W7x and the target device. To run a Traceroute test, type the Traceroute target and
click “Start Traceroute” to being the test.
VLAN MANAGEMENT
If you enable VLAN tagging in the W7x Wireless section under any of the SSIDs, you can choose a VLAN
Management ID for the W7x to access the administrative functions of your W7x. Let’s say you pick VLAN3 to be
the VLAN used for management and the subnet range for VLAN 3 is 192.168.3.X. The IP address for the W7x must
be 192.168.3.X, where X is any value in range.
To Next Page
Loading...
