W7x User Manual
35
7. Finish the configuration of the W7x in Client Bridge Mode by assigning it a unique IP address if it is
not connected to a DHCP server.
8. You should be able to verify performance from the client device by sending a ping request to the IP
address of the Wireless Access Point or by accessing the GUI through your Web Browser at the same
address.
For more detailed setup information on setting up the W7x in Client-Bridge mode see below.
2.4GHZ AND 5GHZ WIRELESS
With the W7x operating in Client Bridge mode, the main menu shows two options under
the Wireless section:
Network Settings
Advanced
Connection Status
To Next Page
Loading...
